<description>assume the top field, lines 0,2,4,... should be displayed first. The default is the supposedly more common BottomFirst but on ATSC captures from my WinTV-HD card TopFirst still works better for me.</description>
<description>0 - No pulldown, 1 - Auto Pulldown, 2 - Pulldown only (Force Film), 3 - Deinterlace (Force Video) but with frame dropping, 4 - Auto Pulldown with frame dropping, 5 - Pulldown only (Force Film) with frame dropping</description>
<description>Helps get rid of noise if needed but causes a 2 field video delay. (Otherwise there's a 1 field delay) Specifying 1 turns it on using the current default of 3 (may change) but you can also specify 2-255 to override this. But values over about 3-5 can cause motion artifacts in fast motion video. This option is disabled!</description>
<description>Not only gets rid of noise but also some deinterlacing artifacts since it's done last, after deinterlace. Useful if you are going to down scale. Use only values 0,1 for parm. This also helps compression.</description>
<description>Add a little sharpness to full res video. This one can also use parm values of 2-100. The default is currently 50 if 1 is specified. I may also support negative values in the future, making it a horizontal filter to help set up for downscaling.</description>
<description>This is a number from 1-255 that must be exceeded before GreedyHMA will do pulldown for a frame. This parm is honored only when Auto Pulldown is also turned on (AP=1 or 4). The default is subject to change but is currently set at 90. But you will get the default value just by specifying 0, which is recommended for most cases.</description>
<description>This is a number from 1-255 that must NOT be exceeded before GreedyHMA will do pulldown for a frame. This parm is honored only when Auto Pulldown is also turned on. The default is subject to change but is currently set at 85. But you will get the default value just by specifying 0, which is recommended for most cases.</description>
